Recent Comments
- Daniel Gamboa on Shake, Rattle & Roll: The MMA8453Q & Arduino
- Daniel Gamboa on Shake, Rattle & Roll: The MMA8453Q & Arduino
- Foomp on Shake, Rattle & Roll: The MMA8453Q & Arduino
- Foomp on Shake, Rattle & Roll: The MMA8453Q & Arduino
- Foomp on Shake, Rattle & Roll: The MMA8453Q & Arduino
- krazatchu on Shake, Rattle & Roll: The MMA8453Q & Arduino
- Foomp on Shake, Rattle & Roll: The MMA8453Q & Arduino
- Jon on What can castellations do for you?
- krazatchu on What can castellations do for you?
- Jon on What can castellations do for you?
- Sebastian on How to: LED as a Light Sensor
- Ryan on Shake, Rattle & Roll: The MMA8453Q & Arduino
Categories
- Arduino (21)
- ASM (1)
- AVR (13)
- Battery (4)
- CNC (6)
- Communication (4)
- Computer Vision (1)
- Connector (3)
- Contiki (3)
- DIY (8)
- Eagle (1)
- Electronics (27)
- Embedded (17)
- Encoder (2)
- How to (19)
- Infra Red (2)
- LEDs (7)
- Low power (3)
- Mechanical (7)
- Motion Control (10)
- Networking (3)
- Off The Wall (1)
- PCB (4)
- Processing (1)
- Product Design (1)
- RF (2)
- Sensors (13)
- Soldering (1)
- Touch Interface (4)
- Uncategorized (1)
- ZigBee (2)
Category Archives: Off The Wall
The Sound of Switchmode
If you’ve ever wondered what different switch mode power supplies would sound like if used to drive a speaker, here is an untested circuit you might try. Using a zener clamped piezoelectric transducer as a contact microphone to push/pull the … Continue reading
Posted in Electronics, Off The Wall, Sensors
Leave a comment